How to Reupholster an ATV Seat

by Mia CarterUpdated August 01, 2023
itstillruns article image
Hemera Technologies/Photos.com/Getty Images

Remove the screws from the metal plates or hinges that affix the seat to the ATV at the point where the seat lifts up.

Use pliers to remove the staples that attach the upholstery to the underside of the seat by grasping each staple and pulling it from the seat bottom. Remove the material.

Slice away the damaged foam cushion beneath the vinyl, separating it from the seat bottom by using a loose, single-edge razor blade.

Turn over the seat bottom and place it atop the new foam, tracing its outline on it.

Cut the new piece of foam, using the pencil marks as a guide.

Apply contact cement to the top side of the seat bottom using a synthetic paint brush. Affix the foam to the top of the seat bottom and allow it to dry per the directions on the contact cement packaging.

Place the new vinyl on a flat surface, with the underside facing up. Lay the old seat cover on top of the new fabric to serve as a template, then trace around it. Include any material slits that are present at the edge of the old seat cover for greater give after re-attachment. The old seat cover can be discarded after this step.

Cut the new seat cover out of the new piece of vinyl, using the pencil outline as a guide. Cut any slits that were also added within the edges.

Place the new piece of vinyl facedown on a flat surface. Flip and center the seat on top of that, so that the foam meets the vinyl's backing.

Wrap the fabric around the top edges of the seat and use a high-powered staple gun run by air compressor to insert tacking staples into the underside of the seat bottom. If you visualize the square seat bottom as a clock face, the staples should be situated at approximately 12, 3, 6 and 9 o'clock. Insert a staple every half inch, securing the new cover in place. As this progresses, periodically flip the seat over and ensure that the vinyl is taut and unwrinkled.

Screw the metal plates back onto the seat bottom and re-attach to the ATV.

More Articles

article divider
×