How to Replace a Serpentine Belt on BMW 325iby Russell Wood
The drive accessories mounted on the front of the engine on a BMW 325i are turned by a serpentine belt. This belt is kept taut by a tensioner, but since the belt is made of rubber, it can stretch or break over time. Replacing the belt is necessary to ensure that the accessories work properly, and should be done when you notice wear on the belt. In this case, the project vehicle is a 2002 BMW 325XI, but the process is similar for other 325s as well.
Pop the hood. Locate the belt-routing diagram, which is a sticker on the core support. Locate the belt tensioner, which is in the middle of the engine, just above the crankshaft pulley.
Place the 3/8-inch ratchet and socket on the hex-head bolt in the middle of the tensioner and turn it counterclockwise to release the tension on the belt. While still holding the ratchet, pull the belt off the pulleys.
Run the replacement belt around the pulleys on the engine, using the sticker you found in Step 1 as a guideline. Then pull the tensioner counterclockwise with the ratchet again, and run the belt around the tensioner. Release the ratchet and verify that the belt is straight and even on each pulley.
Things You'll Need
- 3/8-inch ratchet and socket set
- Replacement serpentine belt
Russell Wood is a writer and photographer who attended Arizona State University. He has been building custom cars and trucks since 1994, including several cover vehicles. In 2000 Wood started a career as a writer, and since then he has dedicated his business to writing and photographing cars and trucks, as well as helping people learn more about how vehicles work.