Python Remote Car Starter Instructions for Reset
by Megan Mattingly-Arthur
Python's remote start system allows users to operate their power locks and start their vehicle with the simple push of a button. Sometimes, after the battery in the car or remote start fob has been changed, the fob won't work until it has been reset.
Step 1
Sit in the driver's seat and close all of the doors. Insert your key into the ignition. Press the "Lock" button on the driver's side door. Turn the key to the "On" ignition position.
Step 2
Press and hold the "Unlock" button on the fob for one to two seconds, and release it.
Step 3
Hold down the "F" button until the fob's indicator light glows red, and release it.
Step 4
Press and hold the "Unlock" button for approximately two seconds, or until the indicator light begins to flash, then release it.
Step 5
Hold down the fob's "Lock" button until the indicator light flashes again, indicating that the fob has been reset successfully.
References
Tips
- Repeat the process to reset up to three additional Python remotes.
Warnings
- Programming instructions may vary slightly between models.
Writer Bio
Megan Mattingly-Arthur has been writing professionally since 1998. She has contributed to various publications, including "Teen Voices" and "Positive Teens" magazines, as well as a book, "The Young Writer's Guide to Getting Published." Mattingly-Arthur is studying travel and tourism through Penn Foster Career School.
