How to Check a Rear Differential
by Robert Moore
All rear-wheel-drive cars and trucks have a rear differential. The rear differential uses a gear set to change the rotation of the transmission and drive shaft by 90 degrees so the wheels will rotate forwards and backwards. The rear differential also allows the rear wheels to rotate at different speeds during turns. The rear differential must be lubricated to prevent excessive wear on the internal gears.
Step 1
Park the vehicle on as level a surface as possible. If you must lift the vehicle to get underneath it, you will need to lift the entire vehicle to keep it level.
Step 2
Inspect the differential cover plate with the flashlight, and look for any leaks around the edges of the plate where it meets with the rear differential.
Step 3
Remove the check bolt by placing the three-eighths-inch-drive ratchet into the square hole on the check bolt.
Step 4
Check the level of fluid by placing a finger into the hole. The fluid should be level with the bottom of the check hole. Place a finger into the hole to get a bit of fluid. The color should be light tan. If it is a different color, the differential fluid needs to be changed.
Step 5
Thread the check bolt back into the differential cover. Tighten the bolt down with the three-eighths-inch-drive ratchet; do not overtighten.
References
- "Automatic Transmissions and Transaxles"; Jack Erjavec; 2010
Tips
- If the differential fluid is low, this may indicate a leak at the axle seals leading to the rear wheels.
- A howling sound coming from the rear end is a common sign of either low differential fluid or extremely worn gears.
Things You'll Need
- Flashlight
- 3/8-inch drive ratchet
Warnings
- Do not drive the vehicle if there is no differential fluid or there is a howling noise. If the differential locks up during operation, both rear wheels will lock up, and it could cause an accident.
Writer Bio
Robert Moore started writing professionally in 2002. His career started has head writer and Web designer for VFW post 1224 in Hamburg, Michigan. He has prepared business plans, proposals and grant requests. Moore is a state of Michigan-certified mechanic and is pursuing an Associate of Arts in automotive technology from Lansing Community College.
