Signs & Symptoms of a Faulty Neutral Safety Switch

by Richard Rowe

All modern cars equipped with an automatic transmission have some sort of neutral safety switch to prevent the car from starting while in gear. The neutral safety switch on most vehicles attaches either to the shift mechanism on the outside of the transmission, or to the shifter mechanism itself. Failure of this switch with prevent the engine from starting under otherwise normal conditions.

Failure to Start

While specific designs vary, the neutral safety switch usually acts as an interrupter between the starter relay and the starter, or the key and the starter relay. During normal operation, the switch's internal circuit will only close while in neutral or park. In no other position will power make it from the ignition key to the relay or the relay to the starter. If your vehicle's starter does not engage in any way when you turn the key in park or neutral, the neutral safety switch may be at fault.

Check Engine Light and Code

The neutral safety switch is an important component in preventing injury and death, so it may be part of your vehicle's diagnostic circuit. Your manufacturer may have incorporated a feedback circuit into your starting system or transmission, allowing the computer to diagnose the problem and notify you via a check engine light. If you suspect a faulty neutral safety switch and your check engine light illuminates, have a technician read the codes with a scanner. Many chain auto parts stores will pull and clear your vehicle's codes for free, but you'll have to get it there first.

Starts in Gear

Modern neutral safety switches are a default-off design, meaning that if the switch fails it will immobilize the vehicle instead of allowing it to start in gear. Still, it's not impossible for contacts to cross over due to moisture in the switch, metallic debris, physical damage, metal shavings from wear or any number of other faults. If this happens, the power side of the switch terminal will short against the housing or power-out terminal to the starter, allowing the vehicle to start in gear. Older neutral safety switches may not incorporate a default-off design, so failure can manifest as a constant-on and starting in gear.

Wiggle the Shifter

One way to diagnose a bad neutral safety switch is to place the shifter into park or neutral, then try to start the engine while gently wiggling the shifter so that it almost goes out of gear. This will engage a different part of the contact inside your switch, allowing power to go through to the starter relay. If your vehicle only starts while wiggling the shifter, then you need to replace the neutral safety switch.

About the Author

Richard Rowe has been writing professionally since 2007, specializing in automotive topics. He has worked as a tractor-trailer driver and mechanic, a rigger at a fire engine factory and as a race-car driver and builder. Rowe studied engineering, philosophy and American literature at Central Florida Community College.

Photo Credits

  • photo_camera fatchoi/iStock/Getty Images