How do I Wire a Ballast Resistor & Coil?

by Tracy Underwood

The typical automotive ignition system prior to 1974 consisted of a coil and ballast resistor, with breaker points to interrupt the current flow when a spark was needed. The job of the ballast resistor was to inhibit current to a level that would not overheat the coil. This simple system is easy for even the novice mechanic to wire. So if you have a classic car with missing ignition components, don't hesitate to replace the coil and ballast resistor yourself.

Step 1

Disconnect the negative terminal of the battery, if there is one installed on the car.

Step 2

Route one end of the wire from the engine compartment into the passenger compartment. Strip 1/2 inch of insulation from the end of the wire and crimp on a ring terminal. Connect it to the ignition terminal of the ignition switch. Route the other end of the wire to one terminal of the ballast resistor. Cut the wire, strip 1/2 inch of insulation and crimp on a terminal. Connect to the ballast resistor.

Step 3

Cut a piece of wire long enough to reach from the other terminal of the ballast resistor to the "Bat", "+" or "B+" terminal of the coil. Strip 1/2 inch of insulation from each end of this wire and crimp a connector onto each end. Connect the wire to the unused terminal of the ballast resistor and to the previously identified terminal of the coil.

Step 4

Locate the small gauge wire that comes out of the body of the distributor. Connect this wire to the negative terminal of the coil.

Step 5

Reconnect the negative terminal of the battery.

More Articles

article divider
×